Description
Converts Dante™ digital audio signal to four discrete line / mic analog signals.
Features
- Single Ethernet port carries Dante audio, power (PoE – class 0)
- LEDs indicate device status and audio signal
- Control strings for third-party preset controllers including Crestron® and AMX®
- 4 Band C/S PEQ on every channel
- Provides channel summing to combine Dante™ signals from the network and send them over a single analog output
- Browser-based software control for all device parameters, per output channel:
- Mute control
- Digital gain
- Polarity control
- 1/3 Rack unit wide
- Chassis ground screw (BLOCK version only) provides common chassis ground for multiple inputs
- Available in block connector and standard XLR variations
Specifications
Input
- (1) RJ45
Outputs
- ANI4OUT-XLR (4) XLR connector
- ANI4OUT-BLOCK (4) 3-pin block connector
- Configuration: Impedance Balanced
- Polarity: Non-inverting, any input to any output
- Power Requirements: Power over Ethernet (PoE), Class 0
- Power Consumption: 10W, maximum
- Weight: 663 g (1.5 lbs)
- Dimensions H x W x D: 4 x 14 x 12.8 cm (1.6 x 5.5 x 5.0 in.)
- Control Application: HTML5 Browser-based
- Operating Temperature Range: −6.7°C (20°F) to 40°C (104°F)
- Storage Temperature Range: −29°C (-20°F) to 74°C (165°F)
Networking
- Cable Requirements: Cat 5e or higher (shielded cable recommended)
Audio
- Frequency Response: 20 to 20,000 Hz
- Input (Dante Digital Audio)
- Channel Count 4
- Sampling Rate 48 kHz
- Bit Depth 24
- Latency
- Does not include Dante latency
- 0.71 ms
- Dynamic Range (Dante-to-Analog)
- 20 Hz to 20 kHz, A-weighted, typical
- 117 dB
- Total Harmonic Distortion
- @ 1 kHz, -20 dBFS Output, 0 dB analog gain
- <0.05%
- Output Clipping Level
- Line +20 dBV
- Aux +0 dBV
- Mic -26 dBV
- Analog Output Level
- Selectable Line 0 dB
- Aux - 20 dB
- Mic -46 dB
- Output Impedance: 150 Ω
- Built-in Digital Signal Processing
- Per Channel Equalizer (4-band Parametric), Mute, Invert Polarity,
- Gain (140 dB range)
- System Audio Summing
