Acoustic Instrument Preamp The Tonebone PZ-Pre is a powerful acoustic instrument preamplifier with a powerful EQ and feedback control section and loads of connectivity options giving you complete control over your rig. Features Two channels to switch or...

Dragster - Load Correction The Dragster™ is a super-compact load correction device that lets you adjust the load on your electric guitar pickup to replicate the sound as if connected directly to a tube guitar amp. Features Adjusts the load on...

Tube Amplifier Head Switcher The Headbone VT is a specially designed switching device that lets you toggle between two tube amplifier heads using a single speaker cabinet. This provides the ability to experiment with different tonal options and perform...

Amp Selector & Boost Pedal The Switchbone V2™ gives you the ultimate control over your two or three-amp setup, with the ability to switch between amplifiers silently, eliminate buzz and hum, and activate a high-powered clean boost for soloing...

This adaptor is designed to change an XLR input into an XLR output.Connector(s): XLR3M to Same

6" Double Layered, Split Level "Pop" Filter Features Nylon 6" screen pop filter 11.5" goose neck and clamp included C-clamp will fit most standard microphone stand and shafts and booms

Active ABY Amp Switcher The Twin-City™ is an active amp selector that lets you connect any two guitar amps and switch between them or drive them both simultaneously without noise, loss of gain, or any degradation to your natural guitar tone...

PSU 42VDC - 110V for Radial products, USA / Canada

Most regular size J-Class enclosures such as the Radial JDI and J48 along with the smaller ProDI and SGI enclosures may be permanently affixed to a desk top, podium or inside a rack should the need arise using either the J-Clamp™ or P-Clamp™...

Most regular size J-Class enclosures such as the Radial JDI and J48 along with the smaller ProDI and SGI enclosures may be permanently affixed to a desk top, podium or inside a rack should the need arise using either the J-Clamp™ or...

Most Radial direct boxes, splitters, isolators and Reampers may be rack-mounted using either the J-Rak 4™ or the J-Rak 8™. These enable multiple units to be combined and safely stored for touring or used as part of a permanent installation...

Most Radial direct boxes, splitters, isolators and Reampers may be rack-mounted using either the J-Rak 4™ or the J-Rak 8™. These enable multiple units to be combined and safely stored for touring or used as part of a permanent installation...