Description
CX311 2way Crossover with Subwoofer Out
The CX311 two-way stereo crossover network has an additional subwoofer output for low-end frequency reinforcement. It employs 24dB/octave state-variable, Fourth-order Linkwitz-Riley filters that guarantee properly phased outputs at all frequencies which is optimal for the proper acoustic summing of common signals from adjacent drivers in the crossover region.
Each channel features independent high and low output level controls and a crossover frequency rotary control which covers a wide range (250hz to 6khz). All three outputs have a 30 cycle low cut switch to eliminate low-end rumble. The subwoofer features an independent output level and rotary control for frequencies in the 50hz to 250hz range.
Features
- Stereo two-way crossover
- Subwoofer output
- Fourth-order Linkwitz-Riley filters (24dB / octave state-variable)
- Independent high and low output level controls
- Crossover frequency rotary control (250hz to 6khz)
- 30 cycle low cut switch
- Independent output level and rotary control (50hz to 250hz)
Specifications
Dimensions: 1.75”H x 19”W x 5.5”D
Weight: 4.85 lbs. (2.2 kg)
Input Connections: XLR, ¼” TRS, balanced
Output Connections: ¼”TS, unbalanced
Input Impedance: 100K ohms
Output Impedance: 220 ohms
Maximum Input Level: +21dBu
Maximum Output Level: +21dBu
CMRR: >75dB (typical @ 1kHz)
Frequency Response: 10Hz to 40kHz, +/-.5dB
Signal to Noise Ratio: >95dB, Ref: 0dBu
20Hz to 20kHz, unweighted
Dynamic Range: >114dB
Total Harmonic Distortion: <0.01% (20Hz-20kHz,0dBu)
Crossover Filter Type: Fourth-order Linkwitz-Riley,
24dB/octave, state-variable
Crossover Frequency Range: 250Hz to 6kHz
Subwoofer Filter Type: Two-pole Butterworth, 12dB/ octave
Subwoofer Frequency Range: 50Hz to 250Hz
Power Requirements: USA – 110-125V AC / 50-60hz/ 15W
Export units configured for country of destination.
ART maintains a policy of constant product improvement. ART reserves the right to make changes in design or make additions to or improvements upon this product without any obligation to install same on products previously manufactured. Therefore, specifications are subject to change without notice.
