Royer Labs - R-122 MKll Live Active Ribbon Microphone

(No reviews yet) Write a Review
SKU:
R-122 MKllL
UPC:
899060002556
Weight:
10.00 LBS
Shipping:
Calculated at Checkout
Availability:
Usually ships within 24 hours.
  • Royer Labs - R-122 MKll Live Active Ribbon Microphone
  • Royer Labs - R-122 MKll Live Active Ribbon Microphone
$1,899.00

Description

The R-122 Live is a road-optimized version of our phantom powered R-122 MKII ribbon microphone. The R-122 MKII Live's output is on par with phantom powered condenser mics, allowing long cable runs with minimal signal loss or RF pickup, and it produces the warm, natural sounds that only ribbon mics can deliver.

R-122 MKll Live Version, Phantom Powered Mono Ribbon - Large Ribbon Element (4-micron), Nickel Finish, switchable bass cut and pad

Features:

  • Phantom powered circuitry provides high output and impedance matching
  • -15 dB pad before the mic’s electronics gives more headroom when activated.
  • Bass cut filter reduces proximity effect and bass below 100 Hz when activated
  • High SPL Capabilities
  • No distortion up to maximum SPL rating
  • Extremely low residual noise
  • Ribbon element is not affected by heat or humidity
  • Absence of high frequency phase distortion
  • Equal sensitivity from front or back of element
  • Consistent frequency response regardless of distance
  • Rear side of mic records slightly brighter when three feet or closer to sound source

Live Applications:

  • Drum Overheads
  • Percussion Instruments
  • Electric Guitar
  • Acoustic Guitar
  • Solo Brass
  • Horn Sections
  • Solo Saxophone
View AllClose

Specifications

Acoustic Operating Principle: Electrodynamic pressure gradient with active electronics.
Polar Pattern: Figure-8
Generating Element: 4-micron aluminum ribbon
Magnets: Rare Earth Neodymium
Frequency Response: 30 - 15,000 Hz ±3 dB
Sensitivity: -36 dB (re. 1v/pa ±1 dB)
Switchable Pad: -15 dB
Switchable Bass Cut: 100 Hz (6 dB per octave)
Self-Noise: < 18 dB
Output Impedance: 200 Ohms, balanced
Output Connector: Male XLR 3-pin (Pin 2 Hot)
Rated Load Impedance: 1K-Ohm minimum
Maximum SPL: 135 dB @ 30 Hz
Power Requirements: 48-Volt Phantom Only
Supply Current: 4 mA
Dimensions: 206mm L X 25mm W (8 1/8” L X 1” W)
Weight: 309 grams (10.9 oz)
Finish: Burnished Satin Nickel / Matte Black Chrome (optional)
Accessories: Protective wood case, mic sock
Optional Accessories: Wind screen, shock mount
Microphone Warranty: Lifetime to original owner (repair or replace at Royer’s option)
Ribbon Element Warranty: One Year

View AllClose

0 Reviews

View AllClose